Autopage RS-600 Operation Manual

Autopage RS-600 Operation Manual

Professional remote car starter & keyless entry system

Advertisement

RS-600
PROFESSIONAL REMOTE CAR STARTER
&
KEYLESS ENTRY SYSTEM
OPERATIONS MANUAL
Please register your product at
www.autopageusa.com
THIS PRODUCT IS DESIGNED FOR PROFESSIONAL INSTALLATION ONLY
1

Advertisement

Table of Contents
loading

Summary of Contents for Autopage RS-600

  • Page 1 RS-600 PROFESSIONAL REMOTE CAR STARTER & KEYLESS ENTRY SYSTEM OPERATIONS MANUAL Please register your product at www.autopageusa.com THIS PRODUCT IS DESIGNED FOR PROFESSIONAL INSTALLATION ONLY...
  • Page 2: System Operations

    SYSTEM OPERATIONS: WARNINGS: As with any product that performs automatic functions, there are certain safety precautions that you must practice and be aware of. 1. Keep the transmitter out of children’s reach. 2. Do not leave anyone in the vehicle while running on remote control. 3.
  • Page 3 CHANGING THE BATTERY IN YOUR TRANSMITTERS XT-33: The XT-33 transmitter uses two (2) 3-volt lithium ion batteries (#CR2016) that are sandwiched together with the (+) side facing upward. To replace the battery, you will need to use a small flat blade screwdriver. Locate the small notch on the lower right side of the transmitter case next to the key ring.
  • Page 4 ACTIVE LOCK: 1. Press button on the transmitter. 2. The horn, if installed will chirp once and parking lights will flash once indicating that the system is now active. The vehicle doors will lock upon activating when interfaced with the keyless entry system. ACTIVE UNLOCK: 1.
  • Page 5: Ignition Control Door Locks

    2. Push and hold valet switch for 2 seconds until the LED turns on. The LED will remain on as long as the system is in ‘valet mode’. Exit Valet Mode: 1. Return to normal operation, turn ignition ‘on’. 2. Push and hold valet switch for 2 seconds, The LED will turn off indicating the system has exited the valet mode.
  • Page 6: To Turn Off The Remote Start

    light will turn on again and climate controls will activate and adjust the vehicles interior temperature to your preset setting. 5. The vehicle will run for 5 to 30 minute cycle and automatically shut down. The duration of the starting mode is programmable. (SINGLE PUSH START OPERATION:) The programmable feature allows you to press the button once...
  • Page 7: Shutdown Input For Remote Starter

    SHUTDOWN INPUT FOR REMOTE STARTER: If any of the following conditions exist while the system is operating, the engine will not start or will shut down immediately: 1. The hood is opened. 2. The brake pedal is pressed. 3. Move the optional remote start enable toggle switch to OFF position. (If installed) 4.
  • Page 8: Autopage Warranty

    Any damages to the alarm system resulting from an installation performed by anyone other than a professional installation technician authorized by a dealer of Auto Page will void the product’s limited lifetime warranty. Autopage Warranty: You must register your product online at http://www.autopageusa.com to receive any warranty service.

Table of Contents