Table of Contents
Advertisement
Console (config)# line console
Console(config-line)# speed 19200
5.12.3 exec-timeout
The exec-timeout line configuration command sets the interval that the system waits until user input is
detected. To restore the default setting, use the no form of this command.
Syntax
exec-timeout minutes [seconds]
no exec-timeout
minutes — Integer that specifies the number of minutes. (Range: 0 - 65535)
seconds — Additional time intervals in seconds. (Range: 0 - 59)
Default Configuration
The default configuration is 10 minutes.
Command Mode
Line Configuration mode
User Guidelines
To specify no timeout, enter the exec-timeout 0 command.
Examples
The following example configures the interval that the system waits until user input is detected to 20
minutes.
Console (config)# line console
Console(config-line)# exec-timeout 20
5.12.4 show line
The show line user EXEC command displays line parameters.
Syntax
show line [console | telnet | ssh]
console — Console terminal line.
Advertisement
Table of Contents
