Lacp Port-Priority; Lacp Timeout - Planet WGSD-1022 User Manual

5.11.2 lacp port-priority

The lacp port-priority interface configuration command configures the priority value for physical ports.
To reset to default priority value, use the no form of this command.
Syntax
lacp port-priority value
no lacp port-priority
value — Port priority value. (Range: 1 - 65535)
Default Configuration
The default port priority value is 1.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the priority value for port e8 to 247.
Console (config)# interface ethernet e8
Console (config-if)# lacp port-priority 247

5.11.3 lacp timeout

The lacp timeout interface configuration command assigns an administrative LACP timeout. To reset the
default administrative LACP timeout use the no form of this command.
Syntax
lacp timeout {long | short}
no lacp timeout
long — Specifies a long timeout value.
Short — Specifies a short timeout value.
Default Configuration
The default port timeout value is long.