Table of Contents
Advertisement
This product series provide three different operating speeds – 10Mbps, 100Mbps, and
1000Mbps in the same switch and automatically distinguish the speed of incoming
connection.
This section describes the hardware features and installation of these Switches. For
easier management and control of the switch, familiarize yourself with its display
indicators, and ports. Front panel illustrations in this chapter display the unit LED
indicators. Before connecting any network device to the switch, read this chapter
carefully.
There are three choices of different modules for expansion:
l
WGSW-D1GT:
l
WGSW-D1SX:
l
WGSW-D1LX:
2.1 Front Panel
The unit front panel provides a simple interface monitoring the switch.
LNK
GSW-1402S
MASTER
STATUS
PWR
ACT
1
2
3
4
5
WGSW-14020
LED indicators
PWR
MASTER
STATUS
ACT
10
LNK
100
1000
LNK – 15/16
LNK STACK
CHAPTER 2. HARDWARE INSTALLATION
10/100/1000Base-T module
1000Base-SX module
1000Base-LX module
1000
STACK
100
SWITCH ID
LNK
10
RESET
6
7
8
9
10 11 12 13 14
15 16
LNK
IN
OUT
WGSW-14020 Switch front panel
Green
On: Power on
Green
When this LED steady green, it means the device acts
competent leading role(Master), an indispensable essential for
system administrator to control and monitor whole system.
At the time one member of the cluster disconnected or new
member joined, the LED blinks. Soon, one and only one master
will be raised. You can refer to "SWITCH ID" for relative
information.
Green
Blink: Run Time Error occurs
Green
Blink: There is traffic transverses the port
Green
On: Indicate link status and traffic speed (10 for 10Mbps, 100 for
100Mbps, 1000 for 1000Mbps)
Green
On: Indicate the link status of network port on module
Green
On: The switch is stacked to others
Off: The switch is standalone or the stack link have problem
1
2
3
4
5
6
7
8
- 3 -
Intelligent 10/100/1000Mbps Ethernet Switch
9
10
11
12
13
14
Advertisement
Table of Contents
