Table of Contents
Advertisement
VLAN Port Configuration
When the VLAN-enabled switch receives an untagged packet, the packet will be sent to
the port's default VLAN according to the PVID (port VLAN ID) of the receiving port.
To change the PVID
Double click the "PVID" column of a port
1.
2.
Input a new VLAN ID (1~255)
Press "Enter" to submit the value
3.
4.
Click Apply button to apply it
NOTE:
1.
All the ports are default as members of VLAN 1 and assigned PVID 1
2.
The port which was assigned a PVID and the PVID is equal to VLAN ID, removing
the port will not allow until you change it
3.
Automatically, a port will join the VLAN of its PVID, and if the VLAN does not exist,
system will create it
4.10 Port Aggregation
Port Aggregation (Port Trunk) is used to increase the bandwidth of a switch-to-switch
connection and backup. This switch provides 8 port aggregation groups, which consist of
2 ports and create bandwidth up to 4Gbps per group at full duplex mode. Check the box of
Aggregation Group in the Status Enable column and press "Apply" then the selected
Aggregation Group is activated.
However, before making connections between switches, pay attention to:
- 25 -
Advertisement
Table of Contents
