Rear Panel - Planet WGSW-14020 User Manual

2.2 Rear Panel

The rear panel of the switch indicates an AC inlet power socket, which accepts input
power from 100 to 240VAC, 50-60Hz, one RS-232 console port for setting up the switch
via a connection to a terminal or PC using a terminal emulation program, and two slide-in
slots for installing additional modules.
15
Slide-in slots
The two slide-in slots on the rear panel are reserved for following optional gigabit
modules. They can provide fat pipes for up linking to backbone or connecting to servers.
The following is the gigabit module operation and cabling required:
Media
1000BASE-T
1000BASE-SX
1000BASE-LX
Console Port
The RS-232 console is an interface for connecting a terminal directly. Through the
console port, it provides rich diagnostic information includes network statistics, link status
and system setting. The operating mode of the console port is:
DCE
9600 (Fix baud rate)
n (No parity checking)
8 (8 Data bits)
1 (1 stop bit)
None (No flow control)
16
WGSW-14020 Switch front panel
WGSW-D1SX
1000BASE-SX : WGSW-D1SX
WGSW-D1LX
1000BASE-LX : WGSW-D1LX
WGSW-D1GT
1000BASE-T : WGSW-D1GT
Speed Duplex Mode Wiring
10Mbps Full / Half
100Mbps Full / Half
1000Mbps Full
1000Mbps Full
1000Mbps Full
CONSOLE
9600, 8, N, 1
TX RX
1000Base-SX
TX RX
1000Base-LX
1000Base-T
Category 3,4,5 UTP/STP
Category 5 UTP/STP
Category 5 UTP/STP
62.5/125 µm MMF
50/125 µm MMF
62.5/125 µm MMF
50/125 µm MMF
9/125 µm SMF
- 5 -
100-240V AC
50-60Hz
Distance
100m
100m
100m
220m
500m
550m
550m
10km