Table of Contents
Advertisement
3.2 Telnet
To access the switch through a Telnet session:
1.
Be Sure of the switch is configured with an IP address and the switch is reachable
from a PC.
2.
Start the Telnet program on a PC and connect to the switch.
The management interface is exactly the same with RS-232 console management except
the "root" priviledge is not supported.
3.3 Main Menu
After you enter the switch's console interface by RS-232 cable or telnet, the following
page is shown. Please enter username and password to access WGSW-14020.
There are three system default accounts for different privilege levels:
"root":
root can do any configuration includes changing password and enable/disable
management capability via console port. The default password of root is
"superuser". Note that this account is not workable on telnet and web
management interface.
"admin"
admin can do any configuration except changing password. The default
password of admin is "admin".
"guest": guest can view the whole switch information only, moreover, access to Web
management interface is not allowed. The default password is "guest".
Main menu appears after successfully login WGSW-14020. To enter any of the
submenus, simply type the number after the command prompt. When select further
options, you may be asked for the device ID which you want to configure. Please just
input the SWITCH ID which you have configured on the switch front panel.
The management functions of console interface are exactly the same with web-based
management interface but in text mode. For further operation, please refer to "4. Web
Management".
- 10 -
Advertisement
Table of Contents
