Setting - Panasonic EASA-PHONE KX-T123211D Installation Manual

Description
11.
Press the MEMORY button.
If you select the automatic switching mode for day/
night service, enter the starting time.
Starting time can be programed for every day of the
week. Refer to " Switching of Service Mode (Day/Night
Service Mode)" on page 3-12.
The LCD will stop blinking.
12.
Press the SELECT button.
" Night: 500 PM" or " Night: None" will be
displayed as the default value and " Night" will
blink.
Press the " q" button.
" 5" or " None" will blink.
0 If " Night: None" will be displayed, press the
SELECT button.
Programming
1.
Dial (07).
" Day/Night Time" will be displayed.
2. Press the NEXT button.
" Day of The Week" will be displayed.
3. Press the NEXT button.
" Sunday" will be displayed.
0 To advance to the next day.
Press the NEXT button.
0 To return to the previous day.
Press the PREV button.
4. Press the SELECT button.
" Day: 9:00 AM" or " Day: None" will be
displayed as the default value and " Day" will
blink.
5. Press the " e" button.
" 9" or " None" will blink.
l If " Day: None" is displayed, press the
SELECT button.
" Day: 9:00 AM" will be displayed.
8. Enter the starting hour for day service using 1
or 2 digits.
l
To set a same mode as last night mode,
press the SELECT button and then proceed
to step 11. :
19.
20.
21.
22.
Press the MEMORY button.
The LCD will stop blinking.
e To advance to the next day of the week, press
the NEXT button.
0 To return to the previous day of the week,
press the PREV button.
Repeat steps 4 to 20 to program the starting
times for each day of the week.
l
To erase a wrong entry, press the CLEAR
button.
To return to the initial program mode, press the
END button.
7. Press the " 9" button.
Programming Table
" 00" will blink.
See page
7-4.
8. Enter the minutes using 2 digits.
9.
Press
the LL G"
button.
"AM"
will blink.
13.
14.
15.
18.
17.
18.
" Night: 500 PM" will be displayed.
Enter the starting time for night service using 1
or 2 digits.
0 To set a same mode as last day made, press
the SELECT button,and then proceed to step
19.
Press the I' a " button.
" 00" will blink.
Enter the minutes using 2 digits.
Press the " +' I button.
" PM" will blink.
Press the SELECT button*to alternate between
" AM" and " PM" to select the correct setting.
10.
Press the SELECT button to alternate between
" AM" and " PM" to select the correct setting.
3-14