Panasonic EASA-PHONE KX-T123211D Installation Manual page 122

:..........,..................
. . . . . until the desired CO number (01 through 12) appears
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AB=
q q
: Disable
q
m: r under 5m seconds :
:.
14 Is] : 62m seconds
m 17]:70
:
. default (all 12 CO' s)
&m :6,4
See the CPC Signal Detect Time table
I
:. ............ until the desired detect time appears
i ...................................
El
: to assign the same on all 12 CO' s
q
1m:onCO12
Description
To detect that an outside party has hung up and
then terminated the outside line (after a
conversation, conference etc.) a CPC signal is
needed. CPC signal detection time can be
removed or changed at customer' s request.
Programming
1.
2.
3.
4.
Dial (55).
" CPC Detection" will be displayed.
Press the NEXT button.
"CO NO? -.' I will be displayed.
Press the NEXT button or dial the CO number
(01 through 12).
" CO 01 : N=42" will be displayed and " 42"
will blink.
Dial the CPC Signal Detect Time number (00,
01, 06 through 75).
5. Press the MEMORY button.
Thn I c?n bill dnn hlinkinn
I I IU LVY " " 111 vrup " ill 11\11 ' 3.
6. 0 To advance to the next CO number, press
the NEXT button.
l
To return to the previous CO number, press
the PREV button.
l
To go to the desired CO nu:mber, press the
SELECT button and then dial the CO
number.
7. Repeat steps 4 to 6, to program the detect
time of the other CO number.
8. To return to the initial program mode, press the
END button.
~" --I---:-_ T-L,,
rruyrarrlrrllrly IdUlt:
.
See page 7-23.
Conditions
0 CPC Signal Detect Time number 02 through
05 can not be used.