Panasonic EASA-PHONE KX-T123211D Installation Manual page 113

_....................................-
until the desired CO number (01 through 12) appears
(...................................................
until the desired jack number appears
m : on jack number 01
_-
m : on jack number 32
_ :_
.
fi[ : to assign the same on all 32 jacks
until the desired mode appears
(all 32 jack numbers)
i ~~~~~~~~" ' zbn jack number 01
EF =m :
to assign the same on all 32 jack numbers
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
I i
I
; . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ;,
'
CD=m : to assign the same on all 12 CO' s
1.
l Dial (45) for day mode.
" Day Out CO" will be displayed.
l
Dial (46) for night mode
2.
3.
" Night Out CO" will be displayed.
Press the NEXTbutton.
" CO NO ? +" will be displayed.
Press the NEXT button or dial the CO number
(01 through 12).
4.
" CO 01 : TFnable" will be displayed.
jack number
Repeat pressing the m button until the
desired jack number appears, or press the
q
button and then dial the jack number.
5. Press the SELECT button to alternate between
" Enable" and " Disable" to select the desired
mode.
6. Press the MEMORY button.
The LCD will stop blinking.
Description
Through programming, you can select which
extensions may be used for outward dialing by
using the day or night mode of operation.
Programming
7. l To advance to the next jack number,
press the m button.
l To return to the previous jack number,
press the m button.
l To go to the desired jack number,
press the
q
button and then dial the
jack number.
8. Repeat steps 5 to 7, to program the assignment
of the other jack numbers.
9. l To advance to the next CO number, press
the NEXT button.
l To return to the previous CO number, press
the PREV button.
l To go to the desired CO number, press the
SELECT button and then dial the CO number.
10. Repeat steps 4 to 9, to program the
assignment of the other CO numbers. .
11. To return to the initial program mode, press
the END button.
Programming Table
See page 7-14 or 7-15.
3-53