Returning A Sensor To Its Factory Defaults; Returning A Receiver To Its Factory Defaults; Replacing A Defective Sensor Or Receiver; Forcing A Sensor To Transmit - Trane WZS Installation & Operation Manual

Returning a Sensor to its Factory Defaults

Returning a Receiver to its Factory Defaults

Replacing a Defective Sensor or Receiver

Forcing a Sensor to Transmit

44
Operation, Maintenance, and Troubleshooting
1. To return a sensor to its factory defaults, set the device address to 000. (For
more information about setting the address to 000, see
Address, " p. 16.)
1. Press the Test button (S5) on the sensor to force the sensor to read the
address switches.
2. Confirm LED operation (see
1. To return a receiver to its factory defaults, set the device address to 000. (For
more information about setting the address to 000, see
Address, " p. 16.)
The sensor reads the address as the switches are set.
2. Confirm LED operation (see
If either the sensor or receiver need to be replaced, follow this procedure:
1. Return the device that is still operational (either the sensor or the receiver) to
its factory defaults (see
2. Replace the malfunctioning or missing device by following the installation
procedures given in
the Receiver and Sensor, " p.
3. Associate the two devices to one another following the association
procedures given in either
Association, " p. 28).
It may be desirable to force a wireless zone sensor to transmit, for example,
during servicing an HVAC unit that is fitted with a wireless zone sensor system.
1. To force a transmission, press Test button (S5) on the sensor.
Table 5, p. 33).
Table 6, p. 33).
"Returning a Receiver to its Factory
"Setting the Address, Mounting, Wiring, and Associating
13.
""Automatic Association, " p.
"Setting the Sensor
"Setting the Receiver
Defaults").
28" or "Manual
Wireless Zone Sensor • BAS-SVX04A-EN