Signal Quality Test - Trane WZS Installation & Operation Manual

Signal Quality Test

Table 3. Signal quality: LED1, LED2, LED3 on the sensor
User action LED display
None LED1: Off
LED2: Off
LED3: Off
Press Test LED1: Off
button (S5)
LED2: Off
LED3: Off
LED1: On
LED2: On
LED3: On
Displays for 5 seconds, then constantly Off
LED1: Off
LED2: On
LED3: On
Displays for 5 seconds, then constantly Off
LED1: Off
LED2: Off
LED3: On
Displays for 5 seconds, then constantly Off
Table 4. Signal quality: LED1, LED2, LED3 on the receiver
User action LED display
None LED1: Off
LED2: Off
LED3: Off
Press Test LED1: On
button (S5)
LED2: On
on the sensor
LED3: On
Displays for 5 seconds, then constantly Off
LED1: Off
LED2: On
LED3: On
Displays for 5 seconds, then constantly Off
LED1: Off
LED2: Off
LED3: On
Displays for 5 seconds, then constantly Off
32
Operation, Maintenance, and Troubleshooting
Pressing the Test button (S5) on the sensor initiates a signal quality test. LED1,
LED2, and LED3 respond by indicating excellent, marginal, or poor signal quality.
The LEDs can be observed on both the sensor (Table 3) and the receiver
Indicates...
Normal state
• No Test button press.
Associated; no communication with receiver
• Associated, but no signal from the receiver after
pressing Test button.
Excellent signal quality
• Adequate signal margin for reliable communication.
Marginal signal quality
• Reduced battery life is likely.
• Consider moving the sensor or receiver to a better
location.
Poor signal quality
• Unreliable communication.
• Strongly recommend moving the sensor or receiver to a
better location.
Indicates...
Normal state
• No Test button press.
Excellent signal quality
• Adequate signal margin for reliable communication.
Marginal signal quality
• Reduced battery life is likely.
• Consider moving the sensor or receiver to a better
location.
Poor signal quality
• Unreliable communication
• Strongly recommend moving the sensor or receiver to a
better location
Wireless Zone Sensor • BAS-SVX04A-EN
(Table 4).