Setting The Rotary Address Switches On The Receiver And The Sensor - Trane WZS Installation & Operation Manual

Setting the Rotary Address Switches on the Receiver and the Sensor

Figure 3. Setting the rotary address switches on the receiver and the sensor
RECEIVER
1
J2
LED1
LED2
LED3
S1 S2
SIGNAL
LED5 A A DDRESS
POWER
HEATING SET
FAN/SYSTEM
SETPOINT
S5
ZONE
GND
24VAC/DC
GND
COMM +
COMM -
BAS-SVX04A-EN • Wireless Zone Sensor
Setting the Address, Mounting, Wiring, and Associating the
Receiver and Sensor
Note: To expedite the installation and association process, set the addresses
before applying power to the receiver.
The process of establishing communication between the receiver and sensor is
referred to as association. The receiver and the sensor must have their rotary
switches set to the same address in order to enable communication between the
two devices (see Figure
• Only one associated receiver/sensor set can communicate within the
reception range of the wireless system.
• It is not possible to associate more than one sensor to a receiver, nor is it
possible to associate more than one receiver to a sensor.
WIRELESS LE LESS
IN TALL TA A TALL
LED4 L L
S4
S3
C33
C34
J1
Each pair of devices must
C35
R77
have a unique address.
3). Important limitations are as follows:
!
Range 001 - 999
SENSOR
B1 +
Pb
Pb-FREE
LED1
LED2
LED3
S3
S1
S2
SIGNAL
LED5
ADDRESS
STATUS
BATTERY
STATUS
S4
WIRELESS
INSTALL
J1
B2 -
15