Sensor Batteries; Battery Type - Trane WZS Installation & Operation Manual

Sensor Batteries

Battery Type

CAUTION
Equipment Damage!
CAUTION
Equipment Damage!
BAS-SVX04A-EN • Wireless Zone Sensor
Operation, Maintenance, and Troubleshooting
Sensor battery type, length of life, and installation are covered in this section.
The batteries are manufactured in a ready-to-use state. They are not designed for
recharging. Recharging can cause battery leakage or, in some cases, can cause
the safety release vent to open.
Do not attempt to hook up the WZS to a power supply. Equipment damage may
result.
Use non-rechargeable 1.5 volt AA lithium batteries in the sensor. Two batteries
are required. To maintain UL rating, only UL-listed lithium batteries should be
used. The sensor ships with Energizer™ L91 batteries already installed.
Note: The sensor is shipped with an insulation barrier between the batteries
(Figure 18) to prevent discharging of the batteries during shipment and
storage. Remove this barrier when installing the sensor (see
the Sensor and Associating the Sensor to the Receiver, " p.
Figure 18. Battery insulation barrier
LED1
LED2
LED3
LED5
S5
B1 +
Pb
Pb-FREE
S3
S1
S2
SIGNAL
LED5
ADDRESS
STATUS
BATTERY
STATUS
S4
WIRELESS
I I NSTALL
J1
B2 -
"Powering
26).
+
–
+
–
35