Agency Compliance - Trane WZS Installation & Operation Manual

Agency Compliance

Table 12. Agency compliance for the Wireless Zone Sensor system
United States compliance
Canada compliance
European conformance
IEEE compliance for radio
frequency range
46
Specifications and Agency Compliance
UL listed: UL 94-5VA Flammability rating
UL 916: Energy management equipment
FCC CFR47, Section 15.247 & Subpart E Digital Modulation Transmission with no SAR (FCC
Identification TFP-13651127)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired operation.
Warning:
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
20 cm separation distance:
To comply with FCC's RF exposure limits for general population/uncontrolled exposure, the
antenna(s) used for this transmitter must be installed to provide a separation distance of at
least 20 cm from all persons and must not be co-located or operating in conjunction with
any other antenna or transmitter.
CSA22.2 No. 205-M1983 Signal Equipment
Industry Canada (Certification no: IC: 6178A-13651127)
Industry Canada statement:
the term "IC" before the certification/registration number signifies only that the Industry
Canada technical specifications were met.
Section 14 of RSS-210:
The installer of this radio equipment must ensure that the antenna is located or pointed such
that it does not emit RF field in excess of Health Canada limits for the general population.
Radio testing standards required for demonstrating compliance with RTTE Directive—1999/
5/EC and EMC Directive 89/336/EEC
ETSO EM 300 328-1 ISM Spread Spectrum 2.4 GHz
IEEE 802.15.4-2003, IEEE Standard for Information Technology—Telecommunications and
information exchange between systems—Local and metropolitan area networks—Specific
requirements, Part 15.4: Wireless Medium Access Control (MAC) and Physical Layer (PHY)
Specifications for Low Rate Wireless Personal Area Networks (LR-WPANs)
Wireless Zone Sensor • BAS-SVX04A-EN