Table of Contents
Advertisement
Universal Repeater
Antenna
Tx Power
After finishing all the settings here, please click OK to save the configuration.
3
.
7
.
3
S
e
c
u
r
i
t
y
3
.
7
.
3
S
e
c
u
r
i
t
y
This page allows you to set security with different modes for SSID 1, 2 and 3 respectively.
After configuring the correct settings, please click OK to save and invoke it.
By clicking the Security Settings, a new web page will appear so that you could configure the
settings.
That is, the wireless client must support this feature and
invoke the function, too.
Note: Vigor N61 wireless adapter supports this function.
Therefore, you can use and install it into your PC for
matching with Packet-OVERDRIVE (refer to the following
picture of Vigor N61 wireless utility window, choose
Enable for TxBURST on the tab of Option).
If such mode is enabled, the access point can act as a
wireless repeater; it can be Station and AP at the same time.
It can use Station function to connect to a Root AP and use
AP function to service all wireless stations within its
coverage.
Check this box to enable the function. Besides, it will be
displayed on the Wireless LAN for you to access for
detailed configuration.
Open Wireless LAN>>Universal Repeater. Please refer to
the corresponding section for detailed information.
Specify the type of the antenna used for your router.
Set the power percentage for transmission signal of access
point. The greater the value is, the higher intensity of the
signal will be.
80
VigorFly 210 Series User's Guide
Advertisement
Table of Contents
