Table of Contents
Advertisement
Item
WPS Current Status
WPS SSID
WPS Auth Mode
WPS Encryp Type
AP PIN
Configure via Push
Button
Configure via Client
PinCode
3
.
7
.
6
W
D
S
3
.
7
.
6
W
D
S
WDS means Wireless Distribution System. It is a protocol for connecting two access points
(AP) wirelessly. Usually, it can be used for the following application:
Provide bridge traffic between two LANs through the air.
Extend the coverage range of a WLAN.
To meet the above requirement, two WDS modes are implemented in Vigor router. One is
Bridge, the other is Repeater. Below shows the function of WDS-bridge interface:
VigorFly 210 Series User's Guide
Description
Display related system information for WPS. If the wireless
security (encryption) function of the router is properly
configured, you can see 'Configured' message here.
Display current selected SSID.
Display current authentication mode of the router. Only
WPA2/PSK and WPA/PSK support WPS.
Display encryption mode (None, WEP, TKIP, AES, etc.) of
the router.
The number displayed here is used for remote client
entering the registrar's PIN code in remote station to make
a network connection.
Click Start PBC to invoke Push-Button style WPS setup
procedure. The router will wait for WPS requests from
wireless clients about two minutes. The WPS LED on the
router will blink fast when WPS is in progress. It will return
to normal condition after two minutes. (You need to setup
WPS within two minutes)
Type the PIN code specified in wireless client you wish to
connect, and click Start PIN button. The WLAN LED on
the router will blink fast when WPS is in progress. It will
return to normal condition after two minutes. (You need to
setup WPS within two minutes.
93
Advertisement
Table of Contents
