Table of Contents
Advertisement
Available parameters are explained as follows:
Item
Current System Time
Use Browser Time
Use NTP Client
Time Zone
NTP Server
NTP synchronization
After finishing all the settings here, please click OK to save the configuration.
3
.
9
.
8
M
a
n
a
g
e
m
3
.
9
.
8
M
a
n
a
g
e
This page allows you to manage the settings for access control, access list, port setup, and
SMP setup. For example, as to management access control, the port number is used to
send/receive SIP message for building a session.
Available parameters are explained as follows:
Item
Enable HTTP/ICMP
Ping/Telnet
Access List
Management Port Setting
VigorFly 210 Series User's Guide
e
n
t
m
e
n
t
Description
Click Inquire Time to get the current time.
Select this option to use the browser time from the remote
administrator PC host as router's system time.
Select to inquire time information from Time Server on the
Internet using assigned protocol.
Select the time zone where the router is located.
Type a new NTP server.
Select a time interval for updating from the NTP server.
Description
Enable the checkbox to allow system administrators to login
from the Internet. There are several servers provided by the
system to allow you managing the router from Internet.
Check the box(es) to specify.
You could specify that the system administrator can only
login from a specific host or network defined in the list. A
maximum of three IPs/subnet masks is allowed.
List IP - Indicate an IP address allowed to login to the router.
Subnet Mask - Represent a subnet mask allowed to login to
the router.
Specify user-defined port numbers for the Telnet and HTTP
121
Advertisement
Table of Contents
