Table of Contents
Advertisement
Troubleshooting
FortiGate-5001A status LED is flashing during system operation
FortiGate AMC modules not detected by FortiGate-5001A board
24
Normally, the FortiGate-5001A Status LED
board is operating normally. If this LED starts flashing while the board is operating,
a fault condition may exist. At the same time the FortiGate-5001A may stop
processing traffic.
To resolve the problem you can try removing and reinserting the FortiGate-5001A
board in the chassis slot. Reloading the firmware may also help.
If this does not solve the problem there may have been a hardware failure or other
problem. Contact Fortinet Technical Support for assistance.
If the FortiGate-5001A board cannot detect the FortiGate AMC module installed in
the FortiGate-5001A front panel AMC opening, the AMC module interfaces will not
be visible from the FortiGate-5001A web-based manager or CLI. Also, the AMC
module HS LED could be solid blue.
To correct this problem you should remove and re-insert the AMC module.
Because AMC modules are not hot swappable, you must first remove the
FortiGate-5001A board.
Caution: Do not operate the FortiGate-5001A board with an open AMC opening. For
optimum cooling performance and safety, the AMC opening must contain a slot filler panel
or a FortiGate AMC module.
Caution: Because the FortiGate-5001A board does not support hot swapping AMC
modules, you must eject the FortiGate-5001A board from its chassis slot and completely
open the handles before inserting or removing AMC modules or slot filler panels.
To remove and reset an AMC module
1
Attach an ESD wrist strap to your wrist and to an ESD socket or to a bare metal
surface on the chassis or frame.
2
Remove the FortiGate-5001A board from the chassis slot.
See
"Removing a FortiGate-5001A board" on page
completely remove the FortiGate-5001A board from the slot; however the board
should be disconnected from power.
3
With the FortiGate-5001A left (top) handle fully open, pull the latch on the AMC
module front panel to open the latch and pull the AMC module out of the
FortiGate-5001A front panel AMC opening.
4
With the FortiGate-5001A left (top) handle fully open, re-insert the AMC module
into the FortiGate-5001A front panel AMC opening.
Make sure the AMC module is inserted correctly into the opening.
5
Close the latch on the AMC front panel.
6
Insert the FortiGate-5001A board into the chassis slot.
Both the AMC module and the FortiGate-5001A board should start up. If both the
FortiGate-5001A board and the AMC module are functioning normally, the front
panel LEDs will appear as described in
page
17.
7
If this does not solve the problem, contact Fortinet Technical Support.
Hardware installation
is off when the FortiGate-5001A
18. You do not have to
Table 4 on page 17
and
Table 5 on
FortiGate-5001A Security System Guide
01-30000-83456-20081023
Advertisement
Table of Contents
