Table of Contents
Advertisement
Inserting a FortiGate-5001A board
16
1
Attach the ESD wrist strap to your wrist and to an available ESD socket or wrist
strap terminal.
2
If required, remove the protective metal frame that the FortiGate-5001A board has
been shipped in.
3
Insert the FortiGate-5001A board into the empty slot in the chassis.
4
Unlock the handles by squeezing the handle locks.
Unlock
Handle
5
Open the handles to their fully open positions.
Caution: To avoid damaging the lock, make sure you squeeze the handles fully to unlock
them before opening. The handles should pop easily out of the board front panel.
Alignment Pin
Handle
Open
Lock
6
Insert the FortiGate-5001A board into the empty slot in the chassis.
7
Carefully guide the board into the chassis using the rails in the slot.
Insert the board by applying moderate force to the front faceplate (not the
handles) to slide the board into the slot. The board should glide smoothly into the
chassis slot. If you encounter any resistance while sliding the board in, the board
could be aligned incorrectly. Pull the board back out and try inserting it again.
8
Slide the board in until the alignment pins are inserted half way into their sockets
in the chassis.
Hardware installation
Alignment Pin
Handle
FortiGate-5001A Security System Guide
01-30000-83456-20081023
Advertisement
Table of Contents
