Table of Contents
Advertisement
FortiGate-5001A security system
LEDs
FortiGate-5001A Security System Guide
01-30000-83456-20081023
Table 1
lists and describes the FortiGate-5001A LEDs.
Table 1: FortiGate-5001A LEDs
LED
State
Description
1, 2
Green
The correct cable is connected to the interface and the
connected equipment has power.
(Left LED)
Flashing
Network activity at the interface.
Green
Off
No link is established.
1, 2
Green
Connection at 1 Gbps.
(Right LED)
Amber
Connection at 100 Mbps.
Off
Connection at 10 Mbps.
Base CH0
Green
Base backplane interface 0 (base1) is connected at 1 Gbps.
Flashing
Network activity at base backplane interface 0.
Green
Base CH1
Green
Base backplane interface 1 (base2) is connected at 1 Gbps.
Flashing
Network activity at base backplane interface 1.
Green
Fabric CH0
Off
Fabric backplane interface 0 (fabric1) is connected at 10
Gbps.
Flashing
Network activity at fabric backplane interface 0.
Green
Fabric CH1
Off
Fabric backplane interface 1 (fabric2) is connected at 10
Gbps.
Flashing
Network activity at fabric backplane interface 1.
Green
Off or
The ACC LED flashes green when the FortiGate-5001A
ACC
Flashing
board accesses the FortiOS flash disk. The FortiOS flash
green
disk stores the current FortiOS firmware build and
configuration files. The system accesses the flash disk when
starting up, during a firmware upgrade, or when an
administrator is using the CLI or GUI to change the FortiOS
configuration. Under normal operating conditions this LED
flashes occasionally, but is mostly off.
Off
Normal operation.
OOS
Green
A fault condition exists and the FortiGate-5001A blade is out
(Out of
of service (OOS). This LED may also flash very briefly during
Service)
normal startup.
Green
The FortiGate-5001A board is powered on.
Power
Off
The FortiGate-5001A board is powered on.
Status
Flashing
The FortiGate-5001A is starting up. If this LED is flashing at
Green
any time other than system startup, a fault condition may
exist.
Blue
The FortiGate-5001A is ready to be hot-swapped (removed
IPM
from the chassis). If the IPM light is blue and no other LEDs
are lit the FortiGate-5001A board has lost power.
Flashing
The FortiGate-5001A is changing from hot swap to running
Blue
mode or from running mode to hot swap. This happens when
the FortiGate-5001A board is starting up or shutting down.
Off
Normal operation. The FortiGate-5001A board is in contact
with the chassis backplane.
Front panel LEDs and connectors
7
Advertisement
Table of Contents
