LOOP Applications
The LOOP OUT L (left) and R (right) outputs allow the signal going through the P6T to
be run to other devices. The LOOP feature of the P6T can be used for any number of
applications. Shown here are only a few examples of how it can be used.
NOTE: The LOOP connectors act as either inputs or outputs. They can
be used as outputs when the LEFT and RIGHT INPUT connectors are
used for input. However, LOOP connectors can also act as inputs when
connected directly to the outputs of a mixer. When the LOOP connectors
are used as inputs, the LEFT and RIGHT INPUT connectors act as
outputs. These diagrams show the LOOP connectors being used as
outputs. Also, the input pad does not affect the level of the LOOP signals.
Running Multiple PSM Wireless Systems Under Stereo Control
The LOOP INPUT connectors can be used to send the same monitor stereo signals to
multiple P6T wireless transmitters. This will free up busses on the mixing console,
allowing you more freedom with your audio system. Simply connect a P6T to the mixing
console as described in Stereo Control, then run
connectors of the first unit to the LEFT/RIGHT Input connectors of the next unit. Connect
subsequent unit in the same way.
Running Floor Monitors Through a P6T Transmitter
The monitor audio signal can be sent through the LOOP connectors to another
amplifier, such as an amplifier for an onstage monitor system. When setup this way, the
P6R and the onstage monitors will have the same audio.
Ñ Ñ Ñ Ñ Ñ
Ñ Ñ Ñ Ñ Ñ Ñ Ñ
P6T #1
Ñ Ñ Ñ
Ñ Ñ Ñ Ñ
P6T #2
MIXER
P6T #3
Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ
Ñ Ñ Ñ Ñ Ñ Ñ
MIXER
1
1
/
-in to
/
-in from the L/R LOOP
4
4
P6R #2
P6R #3
P6T
Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ
FLOOR MONITOR
AMPLIFIER
P6R #1
P6R
9