Getting Started With The Psm600 - Shure PSM600 User Manual

GETTING STARTED WITH THE PSM600 SYSTEM
Thank you for purchasing the PSM600 Personal Stereo Monitor System. The
PSM600 is a revolutionary new product family designed to meet the diverse audio
monitoring needs of musicians, engineers, and stage performers.
This section outlines step-by-step instructions to quickly show you how to connect
your PSM system to an audio source while introducing you to some of its features.
P6T Transmitter Setup
1. Plug the power cord to the power connector.
Connect the other end to a power supply.
2. Attach the antenna to the
ANTENNA OUT BNC connector.
3. Plug the cable(s) from the audio source (mixer,
audio output, CD player) into the LEFT/RIGHT
audio inputs. For a stereo send, use both inputs.
For mono send, use either the LEFT or RIGHT input.
NOTE: All inputs are phantom power
protected up to 60 VDC.
4. Put the PAD switch in the +4 dB if the input
signal is +4 dB, or the –10 dB position, if the
input signal is –10 dB.
5. Turn on the P6T Transmitter.
6. Set the SOURCE switch to match the
audio send (stereo/mono).
7. Set the FREQuency switch in the UP position
to frequency #1.
IMPORTANT:
operating frequency.
8. Power on the audio source and adjust the level control so the LEDs are in the –3
dB to +3 dB range.
P6R Receiver Setup
9. Attach the bodypack antenna (PA710) to the
ANTENNA connector by aligning the red dot and
threading the shell until it is tight.
10. Open the battery door and insert a 9V alkaline battery.
11. Set the DIP switches according to the illustration.
12. Set the balance control to the center detent position.
13. Insert the plug of the earpieces into the headphone
connector on the top panel.
14. Insert the earpieces into your ears.
15. Turn on the receiver by rotating the volume knob clockwise past the click, then
slowly raise the volume to a comfortable listening level.
Now you know the basic setup for your new PSM600 Personal Stereo Monitor
System. If any troubles occur, please refer to the Troubleshooting section of this manual.
The rest of the manual goes into greater detail on features and applications — including
MixModet control, which enables you to customize your own mixes. Please read the rest
of the manual to help you make the most of your PSM600 System.
Never set more than ONE transmitter to the same
#1: UP – Frequency #1
#2: DOWN – Stereo control
#3: UP – High frequency boost
#4: UP – Limiter on
1. 3.
4.
8. 6.
15.
9. 13.
10. & 11.
2.
7. 5.
12.
3