Table of Contents
Advertisement
APPENDIX B. RACK MOUNTING OPTIONS
Rack Mounting the P6T Transmitter
NOTE: Dual mounting with other Shure products. The P6T can also
be dual mounted with a Shure SC or LX half-rack wireless receiver.
These same instructions apply, but the front panels will not align evenly.
The SC and LX receivers must use the SC and LX rack ears. They
cannot be mounted with P6T rack ears. However, the link bars are
universal and can be used to connect the P6T with an LX or SC receiver.
WARNING: Do not torque the screws too tightly, or the chassis may be dam-
aged.
Single Unit
1. Remove the screws and washers from each side of the unit.
2. Align the supplied rackmount brackets over the holes.
3. Using the screws and washers from step 1, fasten the rack-mount brackets.
Dual-Mounted Units
1. Remove the screws and washers on each side of both units.
2. Placing the two units side-by-side, screw the link bars to the inside panels of each
unit. The units are designed so that the link bar on the right unit will fit directly on
top of the link bar of the left unit (facing front). Use two of the screws and
washers from step 1 per link bar to fasten the link bars.
3. Align the rackmount brackets on the outside panels of the units and fasten using
four of the screws and washers from step 1.
NOTE: The link bars are designed with recesses in the side holes where
the screw head and washer fit in. Once the link bars are screwed on
properly, the vertical holes will align. Each link bar has two threaded holes
and two unthreaded holes. In order to ensure proper fit, stack the link bars
so that the unthreaded holes on one bar align with the threaded holes on
the other bar. Then, each pair of screws fits in the opposite direction of the
other pair, ensuring the stability of the link.
4. Place the two units next to each other so the link bars overlap and the screw holes
on the two align.
5. Fasten the link bars together using 4 supplied screws and washers.
15
Hide quick links:
Advertisement
Table of Contents
