MixMode Control
This diagram shows how to connect the PSM600 system with two monitor mixes
combined at the receiver. This allows you to vary the level between the two mixes to
create a custom mix.
Ñ Ñ
Ñ Ñ Ñ Ñ Ñ
Ñ
MIXER
1. Connect the monitor mix 1 and monitor mix 2 mixer outputs of the mixer to the
L/CH. 1 and R/CH. 2 audio inputs of the P6T Transmitter.
2. Set the SOURCE switch on the P6T Transmitter to STEREO.
3. Set DIP switch 2 on the P6R Receiver to MixModet.
4. Set DIP switch 1 on the P6R and the FREQ. switch on the P6T to the same frequency.
5. Use the balance dial on the P6R to adjust the relative levels between the two
monitor mixes.
Mono Control
This diagram shows how to connect the PSM600 system with a mono monitor mix.
MIXER
1. Connect the mono monitor output of the mixer to either the Left or Right audio
inputs of the P6T.
2. Flip the SOURCE switch on the front panel to MONO.
3. Flip DIP switch 2 of the P6R to STEREO.
4. Set DIP switch 1 on the P6R and the FREQ. switch on the P6T to the same frequency.
8
VOICE MIX
Ñ Ñ Ñ Ñ Ñ
Ñ Ñ
BAND MIX
Ñ
P6T
Ñ Ñ Ñ Ñ Ñ Ñ
P6T
FULL LEFT
BAND MIX LOUDER
VOICE MIX LOUDER
P6R
CH. 1
CH. 2
P6R
FULL RIGHT
CH. 1
CH. 2