Overview; P6T Transmitter; Front Panel; Back Panel - Shure PSM600 User Manual

Personal stereo monitor system
Hide thumbs Also See for PSM600:
Table of Contents

Advertisement

OVERVIEW

P6T Transmitter

Front Panel

Ê
Ê
INPUT Dial. This controls the signal level to the
transmitter modulator. For optimum sound, the
input level should be set in the –3 dB to +3 dB
range.
Ë
Stereo INPUT Meters. Each channel has an eight
LED meter which indicates the modulation level of
the radio signal. Important: When the LIM (limit)
LEDs illuminate, the system is overdriven. Reduce
the input knob to keep the input level LEDs at
around –3 dB to +3 dB.
Ì
SOURCE Switch. Set to MONO when only one
input is needed. Set to STEREO/MixMode when
both inputs are needed.
Í
PHONES Volume Dial.
signal level to the headphone output, without
affecting the input level.
Rear Panel
Ê
Power Connector with Integral Fuse. Connects
to a power supply. The fuse is located in the bottom
drawer.
Ë
LOOP OUT Connectors —
balanced. Additional connectors internally wired
to the respective LEFT/RIGHT input connectors.
Ì
INPUT PAD Switch. Selects the input level for –10
dBV or +4 dBu operation.
Ë
Ì
This dial controls the
Ê
Ë
1
/
-in. phone,
4
Í
Î
Î
Headphone Connectors —
1
mm (
/
-in) mini. Each connector is configured as
8
left=tip, right=ring, ground=sleeve. Please note
that only one of these outputs can be used at a
time.
Ï
Frequency Switch and Indicators. This switch
determines the frequency the P6T transmits. The
frequencies your particular unit operates at are
indicated just above this switch. The LEDs indicate
which frequency the unit is transmitting: RED =
frequency 1, GREEN = frequency 2. These LEDs
also act as power-on indicators.
Ð
Power Switch. Press this button to turn the unit on.
Ì
Í
Í
LEFT/CH. 1 and RIGHT/CH. 2 Input Connectors
1
— Combined
/
-in. phone and XLR (female),
4
balanced. Electronically balanced inputs can be
used with either balanced or unbalanced outputs.
Either connector can be used for mono control.
Î
Antenna Connector — 50 Ω, BNC type. This
connects to the antenna to transmit UHF signals to
the receiver.
Ï
Ð
1
/
-in. phone and 3.5
4
Î
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Psm 600

Table of Contents