Intellivolume; Setting Preferences - Onkyo TX-SR653E Instruction Manual

Advanced Setup—Continued

IntelliVolume

You can set the input level for each input source. This is
useful if some of your AV components are louder or qui-
eter than others.
While this menu is shown onscreen, you can select each
input source and set the levels while listening to and
comparing them.
1
Press the [RECEIVER] button fol-
RECEIVER
lowed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "7. Input
Setup," and then press [ENTER].
ENTER
The Input Setup menu appears.
ENTER
3 Use the INPUT SELECTOR but-
tons on the remote controller to
select the input source that you
want to set.
4
Use the Up and Down [
buttons to select
"a. IntelliVolume."
ENTER
If a component is too loud compared to
your other components, use the Left
[ ] button to adjust the level. If it's too
quiet, use the Right [
• The level can be set from –6 dB to
+6 dB.

Setting Preferences

This section explains the items on the Preference menu.
1
2
]/[ ]
3
4
Note:
This procedure can also be performed on the AV receiver
]/[ ]
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
] button.
Press the [RECEIVER] button fol-
RECEIVER
lowed by the [SETUP] button.
The main menu appears onscreen.
Use the Up and Down [
buttons to select "8. Preference,"
and then press [ENTER].
ENTER
The Preference menu appears.
ENTER
Use the Up and Down [
buttons to select the settings,
and use the Left and Right [
ENTER
[ ] buttons to set them.
The settings are explained on page 74.
When you've finished, press the
[SETUP] button.
The setup menu closes.
]/[ ]
]/[ ]
]/
73