Unit Setup For Displayed Temperature - YOKOGAWA Dpharp vigilantplant EJA110A User Manual

b. Setting User-set Engineering Unit
(D21: DISP UNIT)
This parameter allows entry of the engineering units to
be displayed on the BT200. When the instrument is
shipped, this is set as specified in the order.
Follow the procedure below to change this setting.
This parameter need not be set for % display.
• Example: Set an engineering unit M.
Set "M."
SET
D21:DISP UNIT
Press the
M_
enter the setting.
CODE CAPS CLR ESC
Press the
SET
D21:DISP UNIT
M
FEED NO OK
key twice to
(OK) key.
F0821.EPS
8-11
8. BRAIN TERMINAL BT200 OPERATION
c. Lower and Higher Range Value Setup
in Engineering Unit (D22: DISP LRV,
D23: DISP HRV)
These parameter items are used to set the lower and
higher range values for the engineering unit display.
When the instrument is shipped, these are set as
specified in the order. Follow the procedure below to
change these settings. Note that these parameters need
not be set for % display.
• Example: Set lower range value (LRV) to –50
and higher range value (HRV) to 50.
Setting LRV
Set "–50."
SET
D22:DISP LRV
0M
Press the
- 50
enter the setting.
DEL CLR ESC
Setting HRV
Set "50."
SET
D23:DISP HRV
100M
Press the
+ 50
enter the setting.
DEL CLR ESC
Press the
SET
D23:DISP HRV
50M
FEED NO OK
PARAM
D21:DISP UNT
M
D22:DISP LRV
– 50M
D23:DISP HRV
50M
DATA DIAG PRNT ESC

(7) Unit Setup for Displayed Temperature

(D30: TEMP UNIT)
When the instrument is shipped, the temperature units
are set to degC. Follow the procedure below to
change this setting. Note that changing the unit here
changes the unit for A20: AMP TEMP (amplifier
temperature) and A21: CAPSULE TEMP (capsule
temperature).
• Example: Change the unit for the temperature
display.
Use the
SET
D30:TEMP UNIT
deg C
select "deg F."
< deg C >
< deg F >
Press the
ESC
enter the setting.
key twice to
key twice to
(OK) key.
F0822.EPS
or key to
key twice to
F0823.EPS
IM 01C21B01-01E