Figure 2-1: Installing The R17Med Sensor; Figure 2-2: Sensor Cable Connection To Analyzer - Teledyne AX300-I Operating/Service Instructions Manual

Operating Instructions
3. Plug the other end of the cable into the receptacle located on the side of the
unit and secure it using the capture nut. See Figure 2-2.

Figure 2-2: Sensor Cable Connection to Analyzer

Note: Cable shown is for illustration purposes only.
Note: Do not use the plastic flow diverter with the R17MED sensor when the sensor is
used for diffusion sampling (such as with oxygen tents, incubators, etc.). When
the sensor is used with a Tee Adapter, such as in a breathing system, the diver-
ter must be used as shown in Figure 2-3.
Teledyne Analytical Instruments

Figure 2-1: Installing the R17MED Sensor

AX300-I
6