Tag Call; Trunk Flash - Mitel 5235 User Manual

Tag Call

Tag Call allows you to signal that you are the victim of a threatening or
malicious call. Using the tag, your system administrator or Telephone
Company can identify the source of the call and provide this information to
appropriate personnel or authorities.
CAUTION: Tagging a non-malicious call may result in fines or other
penalties.
To tag a malicious call:
• Press the programmed Tag Call key while the call is in progress.
For information on how to program keys, see to
Features On Your Keys
• Press Trans/Conf.
• Dial the appropriate feature access code.
If the call was successfully tagged, Thank You is shown on the display;
otherwise, Not Allowed is displayed.
Note: Tag Call can be used on active two-party calls only. Calls on hold and
conference calls cannot be tagged.

Trunk Flash

The Trunk Flash feature allows you to access Centrex features (if available)
while you are talking on an outside call. To flash a trunk while talking on an
outside call:
1. Press the key you have programmed to Flash.
Note: You can program a key to single flash or double flash.
2. Wait for dial tone.
3. Dial the Centrex feature access code.
-OR-
-72-
Programming