Call Park - Mitel 5235 User Manual

Call Park

The Call Park feature allows you to place a call in a special hold state. You,
or someone else, can then retrieve the call from any extension in the
system. After parking the call, the system can automatically connect you to
paging equipment so that you can announce the call to the requested party.
To park an active call:
1. Do one of the following:
• Press the Call Park feature key (must be programmed)
• Press Trans/Conf command key (
The display shows PARKED@, followed by the park destination and
parking spot index (if applicable). Example: PARKED@ 1234 @ 02.
2. Dial the directory number on which to park the call (not required if the
number is programmed to the Call Park feature key).
3. To inform a user that a parked call is waiting, do one of the following:
• If automatic paging is enabled, announce the call and the park
retrieve digits shown on the display.
• If automatic paging is disabled, press the programmed Page key,
or dial **9, followed by the Paging zone number (if required).
Then, announce the call and park retrieve digits shown on the
display.
Note: Paging over a loudspeaker is not permitted in handsfree
mode; you must use the handset or headset.
To retrieve a parked call:
1. Do one of the following:
• Dial *8#.
• Press the Call Park - Retrieve feature key (must be
programmed).
2. Dial the directory number on which the call is parked (not required if
the number is programmed to the Call Park feature key).
3. When prompted to enter the Parking Slot, enter the two-digit index number
to retrieve a specific call or # to retrieve the longest parked call.
), and then dial *7#.
-57-