Mitel 5235 User Manual page 86

To answer a waiting call on the analog line:
Note: If you have subscribed to an analog call waiting service, you may use
the hookswitch or press Cancel (
When you are on an analog call and a waiting analog call arrives, you
hear a beep. This feature may not be supported in all regions.
To answer a waiting analog call or return to the original analog call:
1. Do one of the following:
• Press and release the hookswitch
• Press Cancel (
2. Press the key you have programmed as Line Interface Module.
To put a current call on hold to answer an incoming analog call:
• Press the highlighted Line Interface Module key.
To switch between the current call and the held call when one of the calls is
using the analog line, do one of the following:
• If your current call is using the analog line, press the flashing Line
key of the held call. The analog call is automatically put on hold.
• If your current call is using an IP line, press the highlighted Line
Interface Module key. The IP line is automatically put on hold.
To end a current call when an incoming analog call arrives:
• Press Cancel (
Module key. The current call ends and you are connected to the
caller on the analog line.
To end the current analog call when an incoming call arrives:
• Press Cancel (
connected to the new caller.
) to answer a waiting analog call.
)
) and then press the highlighted Line Interface
). The current analog call ends and you are
-84-