Sharp SF-2530 Operation Manual page 59

SORTER ORIGINAL TO COPY
(ORIGINALS)
SORT
EVEN NUMBER
ODD NUMBER
STAPLE
SORT
GROUP
PRE-COUNT
ORIGINALS
POWER SAVE
1 2 3
START
4 5 6
7 8 9
0
C
ODD NUMBER
ORIGINAL TO COPY
(ORIGINALS)
EVEN NUMBER
PRE-COUNT
ODD NUMBER
ORIGINALS
2 Ensure that the 1-sided to 1-sided copying mode is
EXPOSURE
selected in the ORIGINAL TO COPY section of the
AUTO
operation panel.
MANUAL
PHOTO
When no indicator in the ORIGINAL TO COPY section is lit, the
1-sided to 1-sided copying mode is selected.
1 2 3 4 5
LIGHT DARK
3 Use the 10-key pad to enter the desired number of
copies.
The number will be shown in the copy quantity display.
Use the clear (
been made.
4 Press the START key.
To cancel a copy run, press the CLEAR ALL (
will stop and the ADF or RADF will output any originals which
have been fed. Also, the number in the copy quantity display will
be reset to 0.
2-sided copies from 1-sided originals
An optional duplex module must be installed for 2-sided copying.
1 Adjust the original guides to the size of the originals and
set the originals face up in the document feeder tray.
If the number of originals is known, use the ORIGINAL
2
TO COPY key to select EVEN NUMBER or ODD NUMBER
in the ORIGINAL TO COPY section of the operation
panel, then proceed to step 3. If the number of originals
is not known, select PRE-COUNT ORIGINALS for an
automatic count by the ADF or RADF and press the
START key.
The number of originals will be displayed in the copy quantity
display.
When the count is complete and the number is known, replace
the originals in the document feeder tray and select EVEN
NUMBER or ODD NUMBER as above.
ADF (SF-A17)/RADF (SF-A56)
) key to cancel an entry if a mistake has
C
) key. Copying
57