Sharp SF-2530 Operation Manual page 35

INTERRUPT
CLEAR ALL
1 2 3
5 6
4
POWER SAVE
START
7 8 9
0
C
@0 Reduction ( ) key (p. 15)
Selects one of four preset reduction copy ratios:
50%, 64%, 77%, or 95%.
@1 Enlargement ( ) key (p. 15)
Selects one of four preset enlargement copy
ratios: 121%, 129%, 141%, or 200%.
@2 100% key (p. 15)
Press to reset the copy ratio to 100% for same-
size copies.
@3 ORIGINAL SIZE indicators
Light up to show the selected original size.
@4 AUTO PAPER SELECT indicator
Paper of the proper size will automatically be
selected depending on the original size and
selected copy ratio when this indicator is on.
@5 PAPER SIZE indicators
Light up to show the selected copy paper size.
@6 Paper feed location/misfeed location indica-
tors (p. 22)
The selected paper feed location is shown by a lit
indicator ( ).
The general location of misfed paper is shown by
a blinking red indicator ( ).
@7 TRAY SELECT key
Press to select the desired paper tray.
@8 10-key pad
Used to set the copy quantity and to make user
program entries.
@9 Zero/readout key
Inputs 0 when specifying the copy quantity.
Press during a continuous copy run to display the
number of copies completed in the current run.
Press during standby to display the total number
of copies made to date.
1st display 2nd display
0/
12,345
Press and hold the key.
3rd display
copies made to date
PART NAMES AND FUNCTIONS
NOTE: 11" x 17" sized copies are counted as
two copies.
#0 Clear ( ) key
C
Press to clear the copy quantity display, or press
during a copy run to terminate copying. The
copier will stop after copies in progress are
finished.
#1 CLEAR ALL ( ) key
Clears all selected settings and returns the
copier to the initial settings.
#2 START key and indicator
Copying is possible when the indicator is on.
Press to start copying.
#3 POWER SAVE indicator (p. 43)
Lights up when the copier is in the preheat mode.
Initial settings
The copier assumes the initial settings when the
CLEAR ALL ( ) key is pressed or approximately 1
minute* after the last copy is made in any mode.
Except for the paper tray selection, the copier also
assumes the initial settings when it is turned on.
Copy ratio: 100%
Automatic exposure
Copy quantity: 0
All special copier modes are set to off.
Tray select: Copier lower tray or an optional 1000-
sheet paper drawer if installed (At power on, the
previously selected tray will again be selected.)
*
This time (auto clear time) can be changed. See
page 34, USER PROGRAMS.
33