Sharp SF-2530 Operation Manual page 41

Program No. 10: Auditing mode
If the auditing mode is enabled, copying is limited to operators with an
assigned 3-digit account number. A maximum of 49, 3-digit account
numbers can be assigned. Use program No. 11 to register account
numbers.
When program No. 10 is entered, the current setting (0: OFF, 1:ON)
will blink on the right side of the copy quantity display.
POWER SAVE
3
1 2
4 5 6
7 8 9
0 C
Program No. 11: Account number entry
Program No. 11 is used to register accounts. When program No. 11
is entered, "––" will appear in the copy quantity display.
If the number of accounts has reached the upper limit (49), "1E" will
appear in the copy quantity display for approximately 5 seconds.
Enter another program number or press the
auditing program.
POWER SAVE
1 2 3
4 5 6
7 8 9
0 C
1. Select the desired setting using the 10-key pad.
0:
1:
START
2. Press the START key.
The setting will be stored.
3. To continue with other auditing programs, enter the
desired program number. To exit the auditing program
mode, press the
key to exit the
1. Enter a 3-digit account number using the 10-key pad.
Any 3-digit number except "000" and the auditor code number
can be registered as an account number.
START
2. Press the START key.
If a number that is already registered or "000" is entered, the
number will blink in the copy quantity display for approximately
5 seconds. Then, "– –" will appear again to prompt account
number entry.
3. Repeat steps 1 and 2 for other account numbers.
4. To continue with the other auditing programs, press the
INTERRUPT key and then enter the desired program
number. To exit the auditing program mode, press the
key.
AUDITING PROGRAMS
OFF
ON
key.
39