Configuration; Configuration For Autocad 13/14 Via Configuration Tool - Ricoh RW-480 PLOTCLIENT HDI/ADI Software Manual

Configuration

To configure RW-480 PLOTCLIENT HDI/ADI you must carry out
two further configurations. First via the program's own configu-
ration tool and then in the print dialog of AutoCAD.
Configuration for AutoCAD 13/14 via configura-
tion tool
If you have deactivated during installation the check box for the
start of the configuration tool in step 9, start the configuration
tool now via "Start – programs – RW-480 – RW-480 – RW-480
PLOTCLIENT HDI ADI – Config" and enter the following settings:
• Select Program
Select RW-480 PLOTCLIENT WIN, from which you wish to send
your print jobs to RW-480 PLOTBASE for printing. If you use the
[HDI/]ADI Client, your presets always only apply for the current
print job. If you take RW-480 PLOTCLIENT WIN, you can add
several other print jobs to your current print job and have the
same presets for all.
• Select AutoCAD version
If you work with one of the two AutoCAD versions R13 or R14,
inform RW-480 PLOTCLIENT WIN which Version you use.
• Configuration
If AutoCAD 13 has not been installed with the standard paths,
inform RW-480 PLOTCLIENT WIN the two paths in which the
configuration file "ACADNT.cfg" and initialization file "ACAD.ini"
are. For AutoCAD 14 no settings are required.
After you have entered the settings in the configuration tool, you
now only have to set up your new printer driver and enter the fi-
nal presets in the print dialog of AutoCAD. You can then start
printing.
CONFIGURATION
RW-480 CLIENTS 93