Sample Print; Page Order - Ricoh RW-480 PLOTCLIENT HDI/ADI Software Manual

Normal, High, Low, Wait. You can alter the priority here or set it
to the highest level.
Job Copies
•
Here you can enter the number of job copies.
• Job Flag Sheet
Activate the "ON" field, if you want an overview of all the infor-
mation that you have entered in this "Job" tab printed out on a
cover sheet. You can add further information in the comments
field below this, which may not have more than a maximum 50
characters. Please do not use any quotation marks.
• Plotter
This default cannot be changed. The RW-480 plotter is preset.
• e-mail
Use of the email function must be switched on in the presets. To
be able to use the email function, Microsoft® Outlook must be
installed. Furthermore "Internet Mail" should be installed.
Here you can instruct the program to automatically send an e-
mail or a message to the user following successful job comple-
tion. To send an email, enter the email address of the user.

• Sample Print

Activate this option, if you want to check the quality of a print
off. Only the first set of copies will then be printed. The print off
of further sets of copies is stopped, so that you can check the
quality of the print off. Then you will be asked, whether you
would like to continue with the print out or abort.
•

Page Order

Here you can choose from three options of pages to be printed
– standard, reverse, auto:
standard: The set entries are printed out in the order they are
shown in the job editor ( 1, 2, 3 ... ). The order of the sheets in
the resulting stack depends on the selected output tray: If the
"front" tray is selected, the order of the sheets in the stack is the
same as the print order: 1, 2, 3,4 ... If the "rear" tray is selected,
the order of the sheets in the stack is reversed: ... 4, 3, 2, 1.
reverse: The set entries are printed out in reverse order ( ... 4,
3, 2, 1 ). The order of the sheets in the resulting stack depends
JOB EDITOR
RW-480 CLIENTS 36