Locked Print - Ricoh RW-480 PLOTCLIENT HDI/ADI Software Manual

JOB EDITOR
on the selected output tray: If the "front" tray is selected, the or-
der of the sheets in the stack is the same as the print order: ...
4, 3, 2, 1 If the "rear" tray is selected, the order of the sheets in
the stack is reversed again. The result is the original: 1, 2, 3, 4..
auto: The print order depends on the selected tray. The order
of the sheets in the resulting stack does not depend on the se-
lected output tray. It is forward ( 1, 2, 3, 4, ... ) in case of tray
"front" and in case of tray "rear".
• Output
You have two possibilities for the output of your printouts on
plotter RW-480: front and rear. The standard setting is output at
the front.

• Locked Print

If you have important print jobs, which others should not be
able to see, activate the "Security" option. Your job can then not
be viewed in RW-480 PLOTBASE by any other person. In the
RW-480 PLOTBASE it only has the status "Password". Print jobs
secured in this way can only be printed out by you entering the
password, which you have set here in RW-480 PLOTCLIENT
WIN. The job is automatically deleted immediately after it has
been printed. For the password, more than 32 characters can
be accepted, however, it is recommended to use 4 to 32 char-
acters!
• Delete
If you activate this option, the job is deleted again by RW-480
PLOTBASE immediately after printing.
RW-480 CLIENTS 37