When There Is No Paper Of The Correct Size - Savin 2045e Operating Instructions Manual

Reception Features
When There Is No Paper of the
Correct Size
If there is no paper in your machine
that matches the size of a received
message, the machine will choose a
paper size based on the paper avail-
able. For example, if your machine
1
has 8 / " 11"K and A3L loaded and
2
you receive a A4L size message,
check the A4L column of the follow-
ing table. The paper size at the top has
highest priority. In this case, since
1
8 / " 11"K is given a higher priority
2
than A3L, the message is printed on
1
8 / " 11"K.
2
5
If only B5 JISL is loaded and you re-
ceive an A3L message, the received
message is stored in memory and not
printed.
v Priority Table
102
Page reduction
Reduction in Sub-
scan Direction
Page Separation
Threshold
Width or Length Pri-
ority
• KK and LL indicate that the
message is split over two pages of
paper with the orientation and size
shown.
Note
r Paper placed in the bypass tray is
not usually selected for printing a
received message. However, you
can use this tray if you select the
bypass tray as the main paper tray
using Reception with Specified
Senders. See p.163 "Special Send-
ers to Treat Differently".
r Widths that this machine can re-
ceive are A4, B4 JIS, LT (8
and A3. Any messages narrower
than A4 or LT (8
1
as A4 or LT (8 /
2
the length unchanged.
r The paper size used to print a re-
ceived message may be different
from the size of the sent original.
r If you specify a receiving tray with
the setting priority under System
Settings, the messages may be re-
ceived in a different order by set-
ting the priority table. The priority
tray may be used only when the
document received is the same size
as the priority tray.
Reference
p . 1 0 0 " P a g e S e p a r a t i o n a n d
Length Reduction"
p.101 "Page Reduction"
p.99 "Image Rotation"
"Tray Paper Settings", General Set-
tings Guide
Disabled
Enabled
20 mm (0.79")
Width
1
/ " 11"),
2
1
/ " 11") are sent
2
" 11") width with