Connecting The Power Cord; Turning The Power On And Off; Turning On The Power; Turning Off The Power - Roland Music Atelier AT-45 Owner's Manual

Connecting the Power Cord

1.
First, make sure that the [Power On] switch at the
panel's left side is OFF (not pushed in).
fig. 00-27
Upper position
OFF
2.
Connect the supplied power cord to the AC Inlet
connector, then plug the other end into an AC
outlet.
NOTE
Only use the power cord supplied with this instrument.
NOTE
Whenever you do not intend to use the instrument for
extended periods of time, pull out the power cord from the
AC outlet.
Turning the Power On and
Off
NOTE
Once the connections have been completed, turn on or off
power to your various devices in the order specified. By
turning on or off devices in the wrong order, you risk
causing malfunction and/or damage to speakers and other
devices.

■ Turning On the Power

1.
Make sure of the following before the power is
turned on.
• Is the power cord correctly connected to the AC inlet?
• Is the power cord correctly connected to the AC outlet?
• Is the [Master Volume] knob set to the Min (minimum)
position?
fig.00-26
Before You Start Playing
2.
Press the [Power On] button to turn on the power.
fig. 00-27
Lower position
Power On
ON
The Power indicator lights in red.
fig.00-28
Power indicator
NOTE
This unit is equipped with a protection circuit. A brief
interval (a few seconds) after power up is required before the
unit will operate normally.
3.
The [Master Volume] knob is an overall control
for adjusting the volume of the entire instrument.
Now adjust the [Master Volume] knob to a suitable level.
The volume will be increased when the Expression Pedal
is pressed down, and decreased when the pedal is
returned.
fig.00-28
decrease
the volume
increase
the volume

■ Turning Off the Power

1.
Before switching the power off, set the [Master
Volume] knob to the Min (minimum) position.
2.
Press the [Power On] button to turn off the power.
fig. 00-27
Upper position
Power On
OFF
17