Midi: Midi Setup / General Controls - Korg pa 500 User Manual

5. You are now asked to set the pedal to the minimum value.
Release the footswitch, or press the pedal to the minimum
position (usually back pressed).
6. Press the "Push" button in the display to confirm the mini-
mum value.
7. Check if the pedal or footswitch is working properly, assign
it a function, then save by choosing the "Write Global-Glo-
bal Setup" command from the page menu.
Damper
Damper Polarity
Polarity of the Damper pedal.
Assignable Slider
Assignable Slider
Functions assigned to the Assignable Slider on the control panel.
See "List of Assignable Pedal and Assignable Slider functions" on
page 271 for a list of the assignable functions. The first functions
are switch-type functions, while the remaining (starting from
Master Volume) are continuous-like functions. Only continuous
functions can be assigned to the sliders.

MIDI: MIDI Setup / General Controls

MIDI: MIDI Setup / General Controls
This page allows you to select a MIDI Setup, convert ordinary
notes to RX Noises, and set global parameters for the MIDI
communication.
Gbl
Gbl
Current MIDI Setup
MIDI Setup
MIDI channels can be automatically configured by selecting a
MIDI Setup. Each of them lets you assign the best values to vari-
ous MIDI parameters, to allow an easier connection with a par-
ticular MIDI controller. See "MIDI" on page 230 for more
information on using MIDI Setups.
A different MIDI Setup may be automatically selected when
entering the Style Play, Song Play or Sequencer modes. To select
a MIDI Setup for these modes, see "Midi Setup" on page 100 for
the Style Play mode, "Midi Setup" on page 162 for the Song Play
mode, and "Midi Setup" on page 196 for the Sequencer mode.
For detailed information on MIDI Setup settings, see "MIDI
Setup" on page 269.
Note: After selecting a MIDI Setup, you can apply any changes to
each channel's settings. To store the changes in memory, select the
Write Global-Midi Setup command in the page menu to save it to
memory (see "Write Global - Midi Setup dialog box" on page 212).
Hint: To restore the original MIDI Setups, load the original Fac-
tory data again (downloadable from www.korgpa.com).
Note to RX Noise
RX Noises are special sounds that make Sounds be more realis-
tic. They are usually located above C7, depending on the Sound.
Enable
When this parameter is turned on, notes received from MIDI, or
performed by one of the internal sequencers, in the RX Noises
range, are recognized and converted to RX Noises. When off,
notes are not recognized.
Note: This parameter is automatically turned off when turning the
instrument on again.
Global edit mode 207
Sty Sng
Seq