JUKI IP-110 Instruction Manual page 7

7 ­Teaching­switch
8 ­Information­switch
9 ­Material­edge­sensor­switch
!0 ­ One-shot­stitching­switch
!1 With/without­automatic­
­­­­­thread­trimmer­switch
!2 Thread­trimming­
­­­­­prohibiting­switch
!3 Counter­value­setting­
­­­­­switch
!4 Max. speed limitation variable
resistor
!5 Power­display­lamp
!6 Media­slot­cover
!7 ­ Media­slot­
­ (Media­inserting­opening)
This­is­the­switch­to­set­the­setting­of­the­number­of­stitches­with­
the­value­of­number­of­stitches­which­has­been­actually­sewn.
This­is­the­switch­to­perform­various­function­settings.
Rendered­effective­when­the­material­edge­sensor­is­installed­on­
the­machine.
Used­for­selecting­whether­or­not­the­material­edge­sensor­is­
used­during­sewing.
When­this­switch­is­set­to­effective­at­the­time­of­program­
stitching,­the­sewing­machine­automatically­operates­up­to­the­
specified number of stitches.
­
When­this­switch­is­set­to­effective­at­the­time­of­program­stitching,­
the­sewing­machine­automatically­performs­thread­trimming­when­
the specified number of stitches has been completed.
This­switch­prohibits­all­thread­trimmings.
*­This­switch­cannot­be­used­with­the­sewing­machine­which­is­
not­provided­with­the­automatic­thread­trimming­device.
This­is­the­switch­to­set­the­value­of­bobbin­thread­counter­or­No.­
of­pcs.­counter.
When moving the resistor in the left direction, max. speed is limited.
This­lamp­lights­up­when­the­power­switch­is­turned­ON.
This­is­the­cover­for­media­inserting­opening.
To open the cover, place your finger on the notch located on the
side of the cover as shown in the figure and push the cover in the
direction­of­left­slanting­rear.
*­There­are­some­functions­that­are­not­able­to­be­operated­
with­the­cover­opened.­Do­not­close­the­cover­unless­the­
CompactFlash(TM)­is­completely­inserted.
To­set­CompactFlash(TM),­place­the­label­face­of­the­
CompactFlash(TM)­to­the­front­and­insert­the­part­that­has­a­
small­hole­(place­the­notch­of­the­edge­to­the­rear)­to­the­panel.­
To remove the CompactFlash(TM), hold it between your fingers
and­draw­it­out.
*­When­the­inserting­direction­of­the­CompactFlash(TM)­is­wrong,­
­­the­panel­and­the­CompactFlash(TM)­may­be­damaged.­Do­not­
­­insert­anything­other­than­the­CompactFlash(TM).
–­4­–