Re-Sewing Switch - JUKI IP-110 Instruction Manual

5-5. Re-sewing switch

The­ re-sewing­ switch­ is­ used­ when­ the­ bobbin­ thread­ runs­ out­ during­ the­ corner­ pattern­ sewing­ step­ or­
the step pattern sewing step. Explanation of the re-sewing switch is given using the corner pattern as an
C
b
a
d
1
)­­ When­the­bobbin­thread­has­run­out­during­the­sewing­of­
a­ corner­ a ,­ take­ the­ position­ at­ which­ you­ have­ noticed­
run­ out­ of­ the­ bobbin­ thread­ as­ b .­ Bring­ the­ pedal­ to­ its­
neutral­position­to­allow­the­sewing­machine­to­stop.
2)­ Depress­ the­ back­ part­ of­ the­ pedal­ to­ perform­ thread­
trimming.
3)­ Press­re-sewing­switch­
4)­­ Replace­ the­ bobbin­ with­ a­ new­ bobbin­ and­ sew­ over­ the­
finished seam. d
5)­­ Depress­ the­ front­ part­ of­ the­ pedal­ and­ continue­ to­ de-
press­the­pedal­until­the­stop­position­of­the­current­step.
6)­­ When­re-sewing­switch­ 1 is­turned­ON­again­at­the­stop­
position,­the­step­is­changed­over­to­the­subsequent­step,­
and­the­corner­pattern­can­be­continued.
*­­ When­ thread­ breakage­ or­ the­ like­ occurs­ during­ the­ free­
stitching­ operation­ d ­ using­ re-sewing­ switch­ 1 ,­ set­ the­
pedal­ to­ neutral­ and­ perform­ thread­ trimming­ operation­
by­depressing­the­back­part­of­the­pedal.­Perform­thread-
ing­ and­ slightly­ return­ the­ material­ edge.­ Then­ press­ re-
sewing­switch­ 1 ­and­the­free­stitching­can­be­continued.­
After­this,­the­operation­is­the­same­as­steps­5)­and­6).
When returning to the first step without
using re-sewing switch 1 , the step
display returns to "1" and the sewing
can be performed from the first by
depressing the back part of the pedal to
perform thread trimming.
–­56­–
.­
1 c