Table of Contents
Advertisement
2-4. Garment body presser/work clamp foot specifications
(1) Garment body presser
2
5
6
A
1. For belt loop shapes Nos. 5 and 7, auxiliary clamps 4 and 6 are damaged since they
are rubbed by the fork pin which rolls the belt loop. If the auxiliary clamps are heav-
ily damaged, they can deform or break. It is necessary to periodically change auxiliary
clamps with new ones.
2. Install the auxiliary clamps at right angles to garment body pressers 1 and 2 . Be sure
to check that the auxiliary clamps do not interfere with other parts.
1
3
4
7
B
Garment body presser 1 and 2 for securing the
garment body is provided as standard with auxil-
iary clamps 3 , 4 , 5 and 6 .
Be aware that the auxiliary clamps 3 may be
required to be removed according to the sewing
shape of the belt-loop.
In the case of two kinds of sewing shapes; No. 2
and No. 6, auxiliary clamp 3 has to be removed.
Loosen two screws 7 and remove the auxiliary
clamps 3 from the garment body presser 1 .
If you have changed the garment body presser,
set the machine setting N802 according to the
garment body presser actually being used.
A Additional clamp is provided
B Additional clamp is not provided
→ Refer to
"@-2-29. How to set the device"
– –
,
p.91.
Advertisement
Table of Contents
