Table of Contents
Advertisement
5-4. Placing a belt loop
2
3
1
Press down multi-layered part detecting bracket
3 and lever 1 of the gear of the loop draw-out
device to put the belt loop into the guide until it is
placed under gear 2 .
When you route the belt loop under
the gear, insert it until it appears from
the belt loop cutting knife.
* In the case the sewing machine is ON, when
multi-layered part detecting bracket 3 is pushed
up, the gear is rotated by the motor to feed the
belt loop.
Route the belt loop in the direction of the arrow.
Finally, route the belt loop in the guide roller sec-
tion on the table to allow it to trail downward.
Position the belt loop below the guide
roller so as to prevent it from being
hitched or being applied with an ex-
cessive resistance at the time of belt
loop feeding.
In the case the optional belt loop feeding unit is to
be mounted on the sewing machine, route the belt
loop as illustrated in the figure at left.
The belt loop feeding unit is provided
with a capability of detecting two dif-
ferent errors; one is the case the belt
loop has knots and the other is the
case the belt loop cannot be fed due
to an excessive resistance.
– 22 –
Advertisement
Table of Contents
