Table of Contents
Advertisement
2-6. How to change the belt loop length
(1) How to change the belt loop dimensions
A
B
1 Displaying the belt loop individual sewing data entry
screen
The belt loop dimensions can be changed on the belt loop
individual sewing data entry screen. On the sewing screen of
the belt loop individual sewing (green), press the set ready
key
to display the belt loop individual sewing data entry
screen (blue).
2 Bringing up the belt loop length entry screen
When you press the button for the belt loop length you want to
change, the corresponding belt loop length entry screen is dis-
played. As an example of belt loop length changing procedure,
take belt loop length A in the belt loop shape No. 4. Press but-
ton
A to display the belt loop length entry screen.
*
Availability of belt loop lengths A to F depends on belt loop
shape (i.e., belt loop shapes No. 1 to No. 7). Therefore, they
can be classified into two groups; one group consists of the
available belt loop lengths and the other consists of the un-
available ones.
*
The initial value and settable range of the belt loop length dif-
fer with the belt loop shape (i.e., belt loop shapes No. 1 to No.
C
7).
3 Entering data
Enter a desired value with numeric keys and +/- button B .
4 Confirming your entry
Press enter button
confirmed.
*
For the other belt loop lengths, you can change the data fol-
lowing the steps of procedure described above.
1. The dimensions of the belt loop sewing shape
displayed on the operation panel are only for refer-
ence. The dimensions vary according to the belt-
loop material. Be sure to adjust the settings of
belt loop dimensions so that your desired finished
dimensions are achieved.
2. Dimension A does not change from the setting even
if you change the sewing shape. This means that
the entire length of the belt loop may be out of the
range (E483) in the event you have changed the
sewing shape.
– 38 –
C , and the data you have entered is
Advertisement
Table of Contents
