Installing Processor Heatsink(S); Figure 31. Installing Processor - Close The Load Plate; Figure 32. Installing Processor - Latch The Locking Lever - Intel S2600CP Service Manual

Hardware Installations and Upgrades
6. Latch the Locking Lever. Push down on the locking lever on the CLOSE 1st side (see letter
"A"). Slide the tip of the lever under the notch in the load plate (see letter "B"). Make sure the
load plate tab engages under the socket lever when fully closed. Repeat the steps to latch the
locking lever on the other side (see letter "C"). Latch the levers in the order as shown.

Installing Processor Heatsink(s)

1. Remove the protective film on the TIM if present.
2. Align heatsink fins to the front and back of the chassis for correct airflow (see letter "A").
Airflow goes from front-to-back of chassis.
Each heatsink has four captive fasteners and should be tightened in a diagonal manner using the
following procedure:
3. Using a #2 Phillips* screwdriver, start with screw 1 and engage screw threads by giving it two
rotations and stop (see letter "B"). (Do not fully tighten.)
4. Proceed to screw 2 and engage screw threads by giving it two rotations and stop. Similarly,
engage screws 3 and 4 (see letter "C").
5. Repeat these steps on each screw with two rotations each time until each screw is lightly
tightened up to a maximum of 8 inch-lbs torque.
26
Figure 31. Installing Processor – Close the Load Plate
Figure 32. Installing Processor – Latch the Locking Lever
®
Intel Server Board S2600CP Intel
®
Server System P4000CP Family Service Guide