B Terminal Emulation Keys (E 40 And E 45 Only) - HP Support Anywhere Installation And User Manual

B Terminal Emulation Keys (E 40 and
E 45 only)
When keyboard commands are redirected to the NetServer's keyboard from a
remote console, keystrokes generated on a generic terminal keyboard may not be
able to control all the NetServer's keyboard keys. When there is no direct
mapping between the remote keyboard and the NetServer keyboard, special keys
on the NetServer keyboard are emulated using character strings.
This is why keys such as ESC and Home must be emulated in the form of ANSI
escape sequences to access HP NetServer E 40 and E 45 functions remotely. If
you choose not to use pcANYWHERE32 (which has pre-defined emulation keys),
you will need to program macro keys to correspond to the Remote Console
Redirection escape sequences.
PC keystrokes that have no ASCII/ANSI terminal equivalents, but are recognized
by the HP NetServer E 40 and E 45 BIOS, can only be used after you have logged
onto the NetServer. These BIOS specific commands are initiated by pressing Alt-
0 (zero) if the terminal has been set up correctly.
Most terminal emulation software permits the mapping of special keys to
character strings. If this is not true of the software you are using, you must send
strings manually. The tables below provide a guide to keyboard emulation, both
with keyboard combinations (where keys are held down together) and keystroke
sequences (where a string of keystrokes is entered).
Sequence Legend
Esc 0 P Fl
Esc 0 Q F2
Esc 0 R F3
Esc 0 S F4
Esc [ @ Insert
Esc [ A Up arrow
Esc [ B Down arrow
Esc [ C Right arrow
Esc [ D Left arrow
Esc [ H Home
Sequence Legend
Esc [1 9 ~ F8
Esc [2 0 ~ F9
Esc [2 1 ~ F10
Esc [2 3 ~ Fll
Esc [2 4 ~ F12
Esc [6 4 ~ cFl
Esc [6 5 ~ cF2
Esc [6 6 ~ cF3
Esc [6 7 ~ cF4
Esc [6 8 ~ cF5
83