Table of Contents
Advertisement
Chapter 3
An HP NetServer running Novell NetWare (4.0 or 4.11) and including
RCONSOLE software and utilities
Minimum Console Requirements
For best results, use an ANSI color terminal that supports 25-line mode and IBM
PC character set. In addition, you will need:
A 386-based (or faster) computer with 6 MB of available disk space
A communications link to the server, either through a modem or a direct
serial connection
Novell NetWare's RCONSOLE program
MSDOS 3.0 or later
Setup at the NetWare NetServer
Enabling a NetWare RCONSOLE connection at your NetServer involves several
steps, including modifying the AUTOEXEC. NCF file and rebooting the server
in order to activate the changes.
To enable a NetWare RCONSOLE connection:
1. Run the NetWare server program and at the server prompt, type:
load install
2. At the NetServer installation utility, select "NCF files options," then
"Edit AUTOEXEC.NCF file".
3. Edit AUTOEXEC.NCF, by typing the following commands, each on a
separate line:
load remote <password> [Enter}
load aio {Enter}
load aiocomx{Enter}
load rs232 <com port> 19200{Enter}
4. Save and exit the edit by pressing [F10], then quit the install program.
5. Take the server off line. Type:
down
6. Quit the NOS. Exit the NetWare environment and enter DOS, type:
60
Installing the HP Support Anywhere Software
Advertisement
Table of Contents
