Table of Contents
Advertisement
Chapter 3
NOTE
If you installed your Network Operating System utilizing the
Configuration Assistant "Express mode" or Custom
"Automated mode" from the HP NetServer Navigator CD
(version F.01.05 and later) , you may skip at least steps 2 to 6
of the Windows NT instructions listed below. If you've also
set the SNMP trap destination of your client during the NOS
install, you may also skip step 1 of the Windows NT
instructions listed below.
If you need to set an IPX address or hostname as the SNMP
trap destination address of your client, you must do steps 1 and
6.
Windows NT Server Setup
To install the Support Anywhere server software on an HP NetServer running
Windows NT:
1. Check SNMP setup to insure proper community name and correct
address. The correct address includes:
IP address of the client
Hostname, if the client is using DHCP
IPX, if Novell NetWare/IntranetWare is the network protocol
In the Windows Program Manager, double-click Control Panel, then
Network. Configure your SNMP Service using the community name and
trap address of your Support Anywhere client workstation (as listed in the
printout you made at the end of the Client setup—see Step 7 in Part 1
above).
2. Insert the HP NetServer Navigator CD-ROM in your server's CD-ROM
drive, or log on to a network-accessible CD-ROM drive.
3. After logging into the server, run File Manager, and then run the Support
Anywhere Setup program located in the following sub-directory on the HP
NetServer Navigator CD-ROM:
X :\HPSA\US\SERVER\DISK1\WINNT\SETUP.EXE
where x is the CD-ROM drive containing the HP NetServer Navigator
CD-ROM.
Installing the HP Support Anywhere Software
33
Advertisement
Table of Contents
